column 7 of the hazardous materials table

In addition, there are over 300 numeric codes provisions. A rocket motor to be considered nonpropulsive must be capable of unrestrained burning and must not appreciably move in any direction when ignited by any means. Where the subsidiary hazard material is Forbidden in column (9A) or (9B) of the 172.101 Table, the radioactive material may only be offered for transportation and transported by aircraft under conditions approved by the Associate Administrator. N32 Aluminum materials of construction are not authorized for single packagings. 389 This entry only applies to lithium ion batteries or lithium metal batteries installed in a cargo transport unit and designed only to provide power external to the cargo transport unit. 383 For transportation by motor vehicle, substances meeting the conditions for high viscosity flammable liquids as prescribed in 173.121(b)(1)(i), (b)(1)(ii), and (b)(1)(iv) of this subchapter, may be reassigned to Packing Group III under the following conditions: a. PDF 171.26 49 CFR Ch. I (10-1-11 Edition) - GovInfo Hazardous materials not necessary for the safe and proper operation of the cargo transport unit must not be transported within the cargo transport unit. Column 7 of the HMT specifies codes for special provisions applicable to packaging, packaging requirements, certification, and marking or labeling for a hazardous material. (a) General. Compressed air containing greater than 23.5 percent oxygen must be shipped using the description Compressed gas, oxidizing, n.o.s., UN3156.. If you have questions or comments regarding a published document please (8) A code containing the letters TP refers to a portable tank special provision for UN or IM Specification portable tanks that is in addition to those provided by the portable tank instructions or the requirements in part 178 of this subchapter. N90 Metal packagings are not authorized. This training must be documented in training records required by 172.704(d). 37 Unless it can be demonstrated by testing that the sensitivity of the substance in its frozen state is no greater than in its liquid state, the substance must remain liquid during normal transport conditions. The map below, compiled from data provided by the Federal Emergency Management Agency (FEMA), is the most accurate nuclear attack map and fallout demonstration available for 2023: (Image courtesy of FEMA and Halcyon Maps) The fallout would rapidly spread, turning targeted cities into whole affected regions. The eCFR is displayed with paragraphs split and indented to follow Metal: 11A, 11B, 11N, 21A, 21B and 21N, b. TP7 The vapor space must be purged of air by nitrogen or other means. 23 This material may be transported under the provisions of Division 4.1 only if it is so packed that the percentage of diluent will not fall below that stated in the shipping description at any time during transport. c. The motor carrier must maintain a satisfactory safety rating as prescribed in 49 CFR part 385. Transport vehicles must be vented to prevent accumulation of vapors at a poisonous or flammable concentration. TP38 Each portable tank must be insulated with an insulating material so that the overall thermal conductance at 15.5 C (60 F) is no more than 1.5333 kilojoules per hour per square meter per degree Celsius (0.075 Btu per hour per square foot per degree Fahrenheit) temperature differential. Each reference in this column to a material which is a hazardous waste or a hazardous substance, and whose proper shipping name is preceded in Column 1 of the Table by the letter "A" or "W", is modified to include " 173.203" or " 173.213", as appropriate for liquids and solids, respectively, on those occasions when the . B59 Water-tight, sift-proof, closed-top, metal-covered hopper cars are also authorized provided that the lading is covered with a nitrogen blanket. 44 The formulation must be prepared so that it remains homogenous and does not separate during transport. The toy plastic or paper caps must be in the form of sheets, strips, rolls, or individual caps; b. Each empty bottle must have a minimum weight of not less than 140 grams and a minimum wall thickness of not less than 0.020 inch (0.508 mm). Column 7 specifies codes for special provisions applicable to hazardous materials. 24 Alcoholic beverages containing more than 70 percent alcohol by volume must be transported as materials in Packing Group II. Individual Name: Mr. David Comen. Further, the limitations and/or additional requirements found in the special provisions of column 7 will supersede the packaging authorizations of column 8 of the Hazardous Materials Table. 110 Fire extinguishers transported under UN1044 and oxygen cylinders transported for emergency use under UN1072 may include installed actuating cartridges (cartridges, power device of Division 1.4C or 1.4S), without changing the classification of Division 2.2, provided the aggregate quantity of deflagrating (propellant) explosives does not exceed 3.2 grams per cylinder. The receptacles must be constructed with glass double walls having the space between the walls vacuum insulated and each receptacle must be transported in an outer packaging with sufficient cushioning and absorbent materials to protect the receptacle from damage. Hazardous Materials Tables | High Road Online CDL Training - TruckingTruth Hazardous materials shipped under this entry are excepted from the labeling requirements of this subchapter unless offered for transportation or transported by aircraft and are not subject to the placarding requirements of subpart F of this part. The organic peroxide must be type D, E, or F, not requiring temperature control. 340 This entry applies only to the vessel transportation of nickel-metal hydride batteries as cargo. The operator of an aircraft carrying hazardous materials must do all of the following EXCEPT: A. b. Heater pipes must be of welded construction designed for a test pressure of 500 psig. Learn more about the eCFR, its status, and the editorial process. TP25 Sulphur trioxide 99.95% pure and above may be transported in tanks without an inhibitor provided that it is maintained at a temperature equal to or above 32.5 C (90.5 F). 117 If shipment of the explosive substance is to take place at a time that freezing weather is anticipated, the water contained in the explosive substance must be mixed with denatured alcohol so that freezing will not occur. For a battery whose voltage (electrical potential) exceeds 9 volts -, (1) When contained in a device, the device must be packaged in a manner that prevents unintentional activation or must have an independent means of preventing unintentional activation (e.g., packaging restricts access to activation switch, switch caps or locks, recessed switches, trigger locks, temperature sensitive circuit breakers, etc. TP26 The heating device must be exterior to the shell. 350 Ammonium bromate, ammonium bromate aqueous solutions, and mixtures of a bromate with an ammonium salt are forbidden for transport. Packages containing mixtures with not less than 90% by mass, of phlegmatizer need not bear a POISON subsidiary risk label. (iii) Constructing the battery with terminals that are recessed or otherwise protected so that the terminals will not be subjected to damage if the package is dropped. b. Portable tanks containing solidified methacrylic acid must not be reheated during transportation. When such batteries are transported in accordance with 173.185(c), the total lithium content of all lithium metal cells contained in the battery must not exceed 1.5 g and the total capacity of all lithium ion cells contained in the battery must not exceed 10 Wh. 74 During transport, this material must be protected from direct sunshine and stored or kept in a cool and well-ventilated place, away from all sources of heat. Sealed packets and articles containing less than 10 mL of a Class 3 liquid in Packing Group II or III absorbed onto a solid material are not subject to this subchapter provided there is no free liquid in the packet or article. 145 This entry applies to formulations that neither detonate in the cavitated state nor deflagrate in laboratory testing, show no effect when heated under confinement, exhibit no explosive power, and are thermally stable (self-accelerating decomposition temperature (SADT) at 60 C (140 F) or higher for a 50 kg (110.2 lbs.) If you would like to comment on the current content, please use the 'Content Feedback' button below for instructions on contacting the issuing agency. For other than Class 7 or the DANGEROUS . The rechargeable lithium ion cells can only be charged from the primary lithium metal cells; ii. N12 Plastic packagings are not authorized. B90 Steel tanks conforming or equivalent to ASME specifications which contain solid or semisolid residual motor fuel antiknock mixture (including rust, scale, or other contaminants) may be shipped by rail freight or highway. Mixtures containing at least 98%, by mass, of phlegmatizer are not subject to the requirements of this subchapter. Other inorganic nitrate salts may replace part of the ammonium nitrate. Authorized specification bulk outer packagings are UN11G fiberboard intermediate bulk containers (IBC) and UN13H4 woven plastic, coated and with liner flexible intermediate bulk containers (FIBCs) meeting the Packing Group II performance level and lined with a plastic liner of at least 6 mil thickness. package). TP4 The maximum degree of filling for portable tanks must not exceed 90%. N11 This material is excepted for the specification packaging requirements of this subchapter if the material is packaged in strong, tight non-bulk packaging meeting the requirements of subparts A and B of part 173 of this subchapter. The first label code represents the primary hazard of the material. Special Provision Letter Codes Used in Hazmat Table, Column 7 Column 7 uses eight letter codes. When a specific portable tank instruction is specified by a T Code in Column (7) of the 172.101 Table for a specific hazardous material, a specification portable tank conforming to an alternative tank instruction may be used if: (A) The alternative portable tank has a higher or equivalent test pressure (for example, 4 bar when 2.65 bar is specified); (B) The alternative portable tank has greater or equivalent wall thickness (for example, 10 mm when 6 mm is specified); (C) The alternative portable tank has a pressure relief device as specified in the T Code. (iii) A copy of the test results must be kept on file at each facility where packagings are offered for transportation, and must be made available to a representative of the Department upon request. In addition, for solid materials, special provision B54 applies. Openings for safety relief devices on multi-unit tank car tanks shall be plugged or blank flanged. 162 This material may be transported under the provisions of Division 4.1 only if it is packed so that at no time during transport will the percentage of diluent fall below the percentage that is stated in the shipping description. For transportation by passenger-carrying aircraft, the net mass of lighter refills may not exceed 1 kg per package, and, for cargo-only aircraft, the net mass of lighter refills may not exceed 15 kg per package. B3 MC 300, MC 301, MC 302, MC 303, MC 305, and MC 306 and DOT 406 cargo tanks and DOT 57 portable tanks are not authorized. Overview of Hazardous Material Transportation Regulations The adsorbent or absorbent material shall not meet the definition or criteria for inclusion in Classes 1 to 8; c. The maximum contents of a receptacle shall be 10 kg of ammonia; and. A chemical under pressure packaged in an aerosol dispenser must be transported under UN1950. 168 For lighters containing a Division 2.1 gas (see 171.8 of this subchapter), representative samples of each new lighter design must be examined and successfully tested as specified in 173.308(b)(3). Shipping papers at all times must reflect a correct current accounting of all cylinders both full and expended. Insulation must be at least 100 mm (3.9 inches) except that the insulation thickness may be reduced to 51 mm (2 inches) over the exterior heater coils. 26 This entry does not include ammonium permanganate, the transport of which is prohibited except when approved by the Associate Administrator. The shipper must ensure that all applicable requirements of 173.185 of this subchapter are met. B16 The lading must be completely covered with nitrogen, inert gas or other inert materials. These detectors must have a minimum burst pressure of 1800 kPa as demonstrated by design type qualification testing; and. Equipment powered by lithium metal batteries or lithium ion batteries must be described using the entries Lithium metal batteries contained in equipment or Lithium metal batteries packed with equipment or Lithium ion batteries contained in equipment or Lithium ion batteries packed with equipment, as appropriate. Retain a copy of each notification of pilot-in-command if requested for up to 30 days Which one of the following hazardous materials is NOT excepted from the quantity limitations in 175.75? Column 1 specifies the T Code. (4) IB Codes and IP Codes. Radiation detectors transported as individual components must be transported as follows: (1) They must be packed in a sealed intermediate plastic liner with sufficient absorbent or adsorbent material to absorb or adsorb the entire gas contents. (i) Column 8: Packaging authorizations. What is Column 7 of the hazardous materials Table?

Spring Island Membership Fees, Fort Pierce Car Accident Today, Nominating Your Boss For An Award Examples, Polk County News Releases, Jill Gascoine Funeral, Articles C

column 7 of the hazardous materials table